top of page

Our Solo2/DL case is designed to mount and protect your lap timer. The case has a rubber inlay for shock absorbtion. It is intended to take the force of the impact instead of transfering it to your lap timer. The case extends over all top edges on the Solo2 but does not block satalite connection. Our mount uses the original AIM plate and the cover goes over and attached to base (AIM mounting plate not included). Case also has tether points for trackday/race orginization compliance. 

 

Mount types:

 

Kawasaki ZX6R Mount: Mounts directly to empty ignition hole on stock ZX6R crown. Lower plate is placed in optimal location in the center of the top clamp while still allowing room for other accessories. Keyed plug fits into ignition hole and locks mount in place. All mounting hardware included for case.

 

Yamaha R1/R6/R7 Mount: Mounts through the clip on alignment holes in the top clamp on stock R1/R6/R7. R1 uses holes closest to the front, R6 and R7 use the rear set of holes. Base plate fits over the top crown nut for lowest possible clearance. 

 

Suzuki GSXR 600/750/1000 Mount: Mounts directly to empty ignition hole on stock GSXR crown. This fits all GSXR600/750 from 2011-2024 and all GSXR1000 from 2007-2024(does not fit the GSXR1000R). Lower plate is placed in optimal location in the center of the top clamp while still allowing room for other accessories. Keyed plug fits into ignition hole and locks mount in place. All mounting hardware included for case.

 

Aprilia RS660 w/ Woodcraft/Robem Crown: Mounts directly to mounting holes on front of crown. Does NOT mount to stock crown. All mounting hardware included for case.

 

1 1/8th Fat Bar Mount: Designed for dirtbike/supermoto bikes, this kit mounts around 1-1/8th handlebar.

 

7/8th Bar Mount: Designed for dirtbike/supermoto bikes, this kit mounts around 7/8th handlebar.

 

Base Plate and Cover: Bolts down from inside the case for the smallest footprint. Mount how and where you like with included 8mm bolt.  

 

Different mounting options are being developed. Please reach out if you have a case mount you want but we dont have listed. 

 

 

Designed and made in the USA. All motorcycle parts have a replacement guarantee. If you break one of our parts in normal use, we will replace. Click here for details.

 

Please be aware that all parts are 3D printed and have visible texture from printing process.

 

For any AIM data products needed, follow the link here or below to UniCal Racing.

AIM Solo2 Case and Mounts

$120.00Price
    bottom of page